F. Controls - Norton C1320P Owner's Manual

Before starting, insure that the blade is properly installed, all
guards are in place and in safe operating condition, and that the
Blade is not in contact with any surface or object. Also verify
that the area where the work is to be preformed is clean, safe,
and has proper ventilation and lighting. Always located and
properly mark all water, gas, and electrical services before
beginning any work.
Locate and under stand the functions of the: Engine Fuel Control Valve
(Located on the Engine under the Air Cleaner), Choke Control (Located On
the Engine under the Air Cleaner), ON/OFF Switch (located on the Operator's
Left Side Top of the Console), and Throttle Control (located on the Operator's
Left Side Top the Console). SEE Section F. Controls for Details on the
locations and operation of the machines controls before operating.
Turn the Fuel Control To the ON Position
3600 RPM
RPM/Hours (RPM/Horas)
Throttle
OFF ON
Emergency
Ignition
Control
Ignicion Paro de
Emergencia
Throttle
Acelerador
Pull The Emergency Kill Switch UP and Push The
Throttle Control Forward to provide some engine
throttle.
Raise
Levantar
Stop
Emergency
Kill Switch
15
Move the choke lever to the CLOSED position.
NOTE: do not use the choke if the engine is
warm or the air temperature is high.
3600 RPM
RPM/Hours (RPM/Horas)
OFF ON
Emergency
Ignition Stop
Ignicion Paro de
Emergencia
Throttle
Acelerador
Place the engine ON/OFF switch to the ON position
Raise
Levantar
On/Off
Switch