Hydrobot Robotic Floor Scrubber Care; Daily Operator Tasks; Startup Tasks; Shutdown Tasks - Intellibot Robotics HydroBot Series User Manual

User Manual - HydroBot Robotic Floor Scrubber

HydroBot Robotic Floor Scrubber Care

Daily Operator Tasks

Startup Tasks

1. Unplug red battery charger plug from rear of robot.
2. Power up and login to the robot.
3. Install cotton filter(s) into blue canister(s). Hand-tighten only.
4. Fill tank with water to prescribed line.
5. Add no more than 3-6 oz. of non-foaming cleaner (e.g. neutral cleaner).

Shutdown Tasks

1. Maneuver robot to fluid dump location. Power off robot.
2. Remove dump hose and position end to dump area. Pull dump handle to
begin dumping fluids.
3. Remove cotton filter(s) from blue canister(s); rinse and set out to dry.
Note: Use filter wrench if necessary.
4. Clean and rinse wire basket.
5. Rinse steel mesh filter and bottom of tank to remove sediment.
6. Close dump handle.
7. Plug red battery charger into the rear of the robot.
© 2012 Intellibot Robotics, LLC All Rights Reserved v2.5 Page 30