Intellibot Robotics HydroBot Series User Manual page 18

User Manual - HydroBot Robotic Floor Scrubber
8. Choose or Ignore left and/or right walls. It is best practice to use
parallel walls and ignore walls that aren't parallel to the cleaning area.
To ignore the wall, press the associated
acquiring the area.
9. Step aside from the rear of the robot to allow it to learn the near wall
distance. The robot will then drive itself down the center of the area
until it encounters an end wall. To pause acquisition, press
stop acquisition of the area, press
10. When the robot has detected an end wall it will stop and display
"Learning Done." To complete the area acquisition, press
11. At the end of each area acquisition there will be an opportunity to edit
the area wall hugs. To edit the left wall hug position, press left wall
(see red arrow).
12. Use the large up and down arrows to change the wall hug position.
Note: To increase in larger increments, press the small yellow up
arrow; to return to smaller increments, press the up arrow again.
© 2012 Intellibot Robotics, LLC All Rights Reserved v2.5
. Press to start
.
; to
.
Page 12