Brush Head Assembly; Squeegee Assembly; Battery Charging - Intellibot Robotics HydroBot Series User Manual

User Manual - HydroBot Robotic Floor Scrubber

Brush Head Assembly

The brush head assembly is a powder-coated stainless steel weldment. The
assembly utilizes dual 24 VDC, 0.75 HP, 200 RPM, direct-drive, permanent,
magnet motors. The two counter-rotating brushes or pads yield a 29" scrubbing
width. Depending on the floor surface, the unit can accommodate various
abrasive grades of pads.

Squeegee Assembly

The HydroBot Robotic Floor Scrubber utilizes a 36-inch, parabolic, self-centering,
swing-style squeegee with plastic rollers on the ends and quick-change, four-
edge, reversible, gum-rubber blades coupled with a powerful vacuum system
that provides outstanding water pickup. The squeegee coverage width is 34.5".
Squeegee blades are removable so they can be cleaned or reversed to get more
service time. It is recommended that squeegee blades be replaced at least every
12 weeks to avoid excessive noise and avoid the potential of leaving water (due
to worn squeegee blades).

Battery Charging

The HydroBot Robotic Floor Scrubbers are installed with gel cell batteries. These
batteries are reliable and do not require a vented room (they do not emit fumes
while recharging). The robot will operate for approximately four hours per battery
pack charge, provided the batteries are in good working order. Intellibot Robotics
offers, as an accessory, a battery exchange system. This system is designed to
allow the operator to exchange the battery pack when low on charge.
Important!
Only 24-volt chargers with a gel cell setting should be used as these chargers
ensure the batteries do not overheat. Using any other charger may cause
damage to the batteries. Charge each battery pack for a continuous eighteen
hours. The robot automatically powers off when the battery-charging plug is
inserted.
© 2012 Intellibot Robotics, LLC All Rights Reserved v2.5 Page 4