Editing Area(S) - Intellibot Robotics HydroBot Series User Manual

User Manual - HydroBot Robotic Floor Scrubber
3. A keyboard screen is used to type in the name of the new Route.
4. When creating a new Route from an existing Zone, this screen allows
the operator to select the Areas to be cleaned within the Zone, the order
they are to be cleaned, and if any Areas should be avoided. By pressing
, the new Route is created and saved on the machine.

Editing Area(s)

It may be necessary to edit certain area parameters to improve navigation, especially after a building renovation. The left
wall position, left offset (left cleaning boundary), right wall position, right offset (right cleaning boundary), near wall position
(wall directly behind robot), near offset (to the rear cleaning boundary), far wall position, and far offset (far cleaning
boundary) values can be edited to improve coverage and overall navigation of an area. Left- and right-hand walls can be
deleted. Note: It may be convenient to delete a wall that is not linear (or non-conforming) such as a non-parallel wall with
many open spaces. However, for reliable navigation, at least one sidewall is required for registration.
1. From the menu, press
2. To begin the editing process, press
© 2012 Intellibot Robotics, LLC All Rights Reserved v2.5
.
.
Page 15