Area Clean; Selecting A Route - Intellibot Robotics HydroBot Series User Manual

User Manual - HydroBot Robotic Floor Scrubber

Area Clean

1. To select area clean, begin by pressing the icon (shown by the red
arrow).
2. From the next menu, select area clean from the list (shown by the red
arrow), then press the right arrow.
Note: The robot may prompt you to move to the starting location of the area.
Follow the instructions on the screen.
Note: The robot will clean the full length of the area until it encounters an end
wall. During the centering pass, the robot will automatically detect the length
and the width of the area, setting the correct number of looping passes to cover
the entire floor surface.

Selecting a Route

1. To select a route, begin by pressing the icon (shown by the red arrow).
2. From the next menu, select the desired route from the list. To scroll to the
next page of listed routes, press the down arrow. To scroll back to the
previous list, press the up arrow.
Note: The robot may prompt you to move to the starting location of the route.
Follow the instructions on the screen.
© 2012 Intellibot Robotics, LLC All Rights Reserved v2.5 Page 7