Intellibot Robotics HydroBot Series User Manual page 19

User Manual - HydroBot Robotic Floor Scrubber
13. Next screen presents the near wall position and near offset edit(s) (the
wall directly behind the robot). Note: It is recommended to edit both
parameters simultaneously, then edit the near offset. Note: The near
offset cannot be larger than the near wall position. Edit values as
appropriate; when finished, press the right arrow.
14. Next screen presents the far wall position and far offset edit(s) (the
wall at the far end of the area). Note: It is recommended to edit both
parameters simultaneously, and then edit the far offset. Note: The far
offset cannot be larger than the far wall position. Edit values as
appropriate; when finished, press the right arrow.
15. Next Summary Edit screen displays the old and new values. Review
the values for accuracy. If changes are required, press the left arrow
key and return to a previous screen to make changes. To finish
editing, press the green check mark.
16. The robot will prompt 'Is there another Area to learn in this zone?' If
yes, press the green check mark; if no, press the red X (proceed to
step 22 of this procedure).
17. The robot will prompt 'Is the machine at the correct starting position
of the Area to learn?' If yes, press the green check mark (repeat steps
5 thru 18 of this procedure); if no, press the red X (proceed to step 20
of this procedure).
© 2012 Intellibot Robotics, LLC All Rights Reserved v2.5 Page 13