Pausing And Restarting; Changing Pads Or Brushes; Exchanging Battery Packs - Intellibot Robotics HydroBot Series User Manual

User Manual - HydroBot Robotic Floor Scrubber

Pausing and Restarting

In the event of an emergency (e.g. building evacuation, etc.), it may become
necessary to pause or stop the robot during an autonomous cleaning routine (e.g.
area clean, route, etc.).
1. To pause the robot during autonomous cleaning, press
press from the next screen.
2. To stop the robot and abort the run, press

Changing Pads or Brushes

1. Power off robot.
2. Open front door.
3. Grasp the pad drivers (or brushes) as shown by the red arrows. Deliver a
quick turn in the direction of the arrows to release the pad driver (or
brush).
4. Flip pad driver. Squeeze together the locking clip (shown be red arrow) to
release the locking cap.
5. Remove pad from driver.
6. Install new pad onto driver then lock cap in place.
7. Mount pad drivers on spindles using a quick turn in the opposite direction,
as shown by the arrows.
Note: Dirty or worn pads can cause excessive drag, shortening battery run time.
Flip and/or change pads often.

Exchanging Battery Packs

1. Set parking brake on (to left).
2. Power robot off.
3. Position battery cart to engage latching gate (use level to drop gate in
place).
4. Press down on battery pack locking latch. Lock casters.
5. Pull battery pack onto battery cart.
6. Release locking latch and casters.
7. Spin battery cart 180 degrees to align new battery pack.
8. Engage latching gate and lock casters.
9. Push battery pack into place until handle latch locks.
© 2012 Intellibot Robotics, LLC All Rights Reserved v2.5
; to resume,
.
Page 8