Jenn-Air JES9750CAB00 Installation Instructions Manual page 52

6. Connect vent system to blower motor outlet (option 1 shown)
with 4 - #8 x 3_,,hex head screws provided.
A. Inlet
B. Vent clamp
C. Floor
D. Vent system
7. Go to the "Electrical Connection" section.
Left or Right Side Venting
1. Mark cabinet side for either a left or right side vent hole
location.
3=
4=
Mark and cut a 14" x 11" (35.6 x 27.9 cm) opening in the floor
of the same cabinet as the vent hole opening.
Top View
A. 11" (27.9 cm) from front of cabinet
B. 14" (35.6 cm) from left side of cabinet
Remove 4 Iocknuts on the motor side of the blower and
remove the bracket.
View from Motor Side of Blower
2=
A. 31 _" (79.2 cm) to top of cabinet
B. 18" (45.7 cm) from back wall
Mark and cut a 51/2"(13.9 cm) diameter hole in the desired
cabinet side.
A. 5V2" (13.9 cm) diameter hole
5=
A.Electrical connector
Lift and rotate the motor 180 ° to reposition the electrical
connection.
/
A. Electrical connector
6. Rotate bracket 180 ° and secure with 4 Iocknuts.
12