Style 2: Direct wire strain relief
•
Use Phillips screwdriver to remove screws from panel on
back of range.
•
Replace cord/conduit
plate and insert screws.
•
Lift range back panel up and off.
Assemble a UL listed conduit connector
in the opening.
F..............
!
Use Phillips screwdriver to remove screws and slide
cord/conduit
plate down and out.
Position cord/conduit
plate as shown in the following
illustration.
5=
6.
t
A. Removable retaining nut
B. Strain relief
•
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
•
Tighten strain relief screw against the flexible conduit.
Replace back panel and screws on rear of range.
Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
15