ZyXEL Communications MGS-3712/MES-3728 User Manual page 89

Table 11 Basic Setting > IP Setup (continued)
LABEL
Apply
Cancel
In-band IP Addresses
You can create up to 64 IP addresses, which are used to access and manage the Switch
from the ports belonging to the pre-defined VLAN(s). You must configure a VLAN first.
IP Address
IP Subnet Mask
VID
Default Gateway
Add
Cancel
Index
IP Address
IP Subnet Mask
VID
Default Gateway
Delete
Cancel
MES-3728 User's Guide
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory.
The Switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the fields again.
Enter the IP address for managing the Switch by the members of the
VLAN specified in the VID field below.
Enter the IP subnet mask in dotted decimal notation.
Type the VLAN group identification number.
Enter the IP address of the default outgoing gateway in dotted
decimal notation.
Click Add to insert the entry to the summary table below and save
your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link
on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
This field displays the index number of the rule. Click an index
number to edit the rule.
This field displays the IP address.
This field displays the subnet mask.
This field displays the ID number of the VLAN group.
This field displays the IP address of the default gateway.
Check the management IP addresses that you want to remove in the
Delete column, then click the Delete button.
Click Cancel to clear the selected check boxes in the Delete column.
Chapter 8 Basic Setting
89