Table of Contents
Advertisement
Chapter 42 Product Specifications
Table 124 Hardware Specifications
LEDs
Operating
Environment
Storage Environment
Ground Wire Gauge
Power Wire Gauge
Fuse Specification
External Signal Jack
External Signal
connector
Table 125 Firmware Specifications
FEATURE
Default IP Address
Default Subnet Mask
Administrator User
Name
Default Password
Number of Login
Accounts Configurable
on the Switch
Maximum Frame Size
360
Per switch: BPS, PWR, SYS, ALM
Per Fast Ethernet RJ-45 10/100 port: LNK/ACT
Per mini-GBIC slot: LNK, ACT
Per 1000BASE-T RJ-45 port (in dual personality interface): LNK/
ACT, FDX
Per Management port: 10, 100
Temperature: 0ºC ~ 65ºC (32ºF ~ 149ºF)
Humidity: 10 ~ 90% (non-condensing)
Temperature: -10º C ~ 70º C (14º F ~ 158º F)
Humidity: 10 ~ 90% (non-condensing)
18 AWG or larger
18 AWG or larger
250 VAC, T2A
Supports input from four external alarms or other devices and
output to one device.
•
Input: connect any one of the input pin pairs (4,5) (6,7) (8,9)
(10,11) to a normally open (NO) dry contact device without
any external input power. An alarm is triggered when the
circuit is closed.
•
Output: dry contact (support 20 VDC, 500mA only), connect
the output pin pair (1,2) to a device in Normal Close (NO)
operation and/or pin pair (2,3) to a device in Normal Open
(NO) operation.
Standard Wire Gauge: 20 ~ 28 AWG
Wire strip length: 6 ~7 mm
DESCRIPTION
In band: 192.168.1.1
Out of band (Management port): 192.168.0.1
255.255.255.0 (24 bits)
admin
1234
4 management accounts configured on the Switch.
Authentication via RADIUS and TACACS+ also available.
9 K (9216 bytes)
MES-3728 User's Guide
Advertisement
Table of Contents
Troubleshooting
