ZyXEL Communications MGS-3712/MES-3728 User Manual page 349

The following table describes the labels in this screen.
Table 123 Management > Configure Clone
LABEL
Source/
Destination
Port
Basic
Setting
Advanced
Application
Apply
Cancel
MES-3728 User's Guide
DESCRIPTION
Enter the source port under the Source label. This port's attributes are
copied.
Enter the destination port or ports under the Destination label. These are
the ports which are going to have the same attributes as the source port.
You can enter individual ports separated by a comma or a range of ports by
using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Select which port settings (you configured in the Basic Setting menus)
should be copied to the destination port(s).
Select which port settings (you configured in the Advanced Application
menus) should be copied to the destination ports.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 40 Configure Clone
349