ZyXEL Communications MGS-3712/MES-3728 User Manual page 179

Table 45 Advanced Application > Classifier (continued)
LABEL DESCRIPTION
Packet Specify the format of the packet. Choices are All, 802.3 tagged, 802.3
Format untagged, Ethernet II tagged and Ethernet II untagged.
A value of 802.3 indicates that the packets are formatted according to the
IEEE 802.3 standards.
A value of Ethernet II indicates that the packets are formatted according to
RFC 894, Ethernet II encapsulation.
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN Select Any to classify traffic from any VLAN or select the second option and
specify the source VLAN ID in the field provided.
When VLAN mapping is enabled, this is the translated VLAN ID you set in the
VLAN Mapping Configure screen If the incoming traffic is tagged and
matches a VLAN mapping rule.
Priority Select Any to classify traffic from any priority level or select the second option
and specify a priority level in the field provided.
Ethernet Select an Ethernet type or select Other and enter the Ethernet type number in
Type hexadecimal value. Refer to
Source
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a source, select the second choice and type a MAC address in valid
MAC address format (six hexadecimal character pairs).
Port Type the port number to which the rule should be applied. You may choose one
port only or all ports (Any).
Destination
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a destination, select the second choice and type a MAC address in
valid MAC address format (six hexadecimal character pairs).
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP Select Any to classify traffic from any DSCP or select the second option and
specify a DSCP (DiffServ Code Point) number between 0 and 63 in the field
provided.
IP Select an IP protocol type or select Other and enter the protocol number in
Protocol decimal value. Refer to
You may select Establish Only for TCP protocol type. This means that the
Switch will pick out the packets that are sent to establish TCP connections.
Source
MES-3728 User's Guide
Table 47 on page 181
Table 48 on page 182 for more information.
Chapter 20 Classifier
for information.
179