NovaJet 500/630/700 Series Printer Quick Start Guide
Assembling the dryer on the NovaJet 500, 505, 630 and 700
Use this section, if you ordered a takeup and dryer for the NovaJet 500, 505, 630
or 700. The following section will describe the installation of a takeup and dryer
system on the NovaJet 750.
1
Remove the wing nut and mount the dryer assembly in the slots
provided at the base of the stand. Be sure fans will blow upward and
toward the printer. Position the dryer assembly to the desired angle.
Replace and tighten the wing nut on the left side.
2
Plug the dryer connector into the receptacle on the right stand leg.
Media
sensors
Sensor
connector
Dryer
connector
8
Set dryer assembly into
the slot on the bracket
Adjust to desired position
and tighten wing nut