ENCAD 212528-05 Quick Start Manual page 30

NovaJet 500/630/700 Series Printer Quick Start Guide
11 If all colors look fine, go on to step 15. If any color drops out, prime
cartridges as necessary, using the ink primer. Place the suction end
of the ink primer over the jet area of the cartridge.
12 Make sure the ink primer is making good contact with the jet area.
Pulse the pump 3 - 5 times, until the ink is visible in the ink primer
sight tube. Maintain good contact between the inkjet plate and the
pump for an additional 5 seconds.
When removing the ink primer, use the silicone tip to wipe and clean
the jet plate. Remember to clean the silicone tip of ink before moving
to the next cartridge.
13 Reprint the color test and prime test pattern. (The paper axis test is
only required when changing media). Inspect to ensure proper
pressure is maintained for each color.
14 Re-prime cartridges as necessary to remove clogs. Manually
bypass (compensate) clogged jets as necessary. Manual
compensation is described later in this guide.
15 Once all cartridges are working correctly, print the color deadband
and color calibration test patterns as described in the section on
Aligning the ink cartridges which follows.
30
Switch
Sight
Tube