ENCAD 212528-05 Quick Start Manual page 15

➪ ➪ ➪ ➪ ➪
To load roll media on all other printers
1 Slide the roll media onto the top roller, orienting it as shown below.
Slide the media guide into the roll core, and tighten the guide to
secure the roll. Insert the media's leading edge into the back of the
printer, aligning the paper edge with the alignment mark on the
platen. The printer will sense the presence of the media and feed it
automatically.
Media presence
Note: If you are going to use the optional takeup roll, be sure that a
media core is installed on it. Attach the leading edge of the media
to the takeup roll with three pieces of tape: one at the left, right, and
center of the core. Orient the media as shown in the preceding
illustration.
As printing progresses, media loops down in front of the takeup
core and will be detected by the sensor on the printer stand leg.
The takeup roll will then be activated to roll the media. Be sure not
to block the sensor!
2 Adjust the media edge guides on the back of the printer. 1/16" gap
spacing is optimum.
NovaJet 500/630/700 Series Printer Quick Start Guide
Left side view
sensor
Feed
roll
Takeup roll
Loading roll media
Media sensors for
feed and takeup
15