ENCAD 212528-05 Quick Start Manual page 28

NovaJet 500/630/700 Series Printer Quick Start Guide
➪ ➪ ➪ ➪ ➪
To install 630/700 series tube needle assemblies and prime
the ink delivery lines
1 Snap the tube needle assembly connector into the fitting on the
carrier. Insert the needle into the small hole on the ink primer. There
are two connectors for each cartridge - one is blue and the other is
gray. Be sure that the tube needle assembly is plugged into the
same color connector as the ink reservoir.
2 Press the button on the ink primer to activate the vacuum and draw
ink from the reservoir into the needle.
3 When ink is visible in the ink primer sight tube (should take 5-10
seconds), remove the cartridge needle from the ink primer and
quickly insert it into the hole in the top of the ink cartridge. Be sure
the needle is tightly connected by turning the fitting clockwise until
finger-tight.
4 Gently tighten the fitting (about 1/4 turn) to prevent air leaks. Do not
overtighten. Wait 20 seconds for the ink pressure to stabilize.
28