ENCAD 212528-05 Quick Start Manual page 33

5 Press the button on the ink primer to activate the vacuum and draw
ink from the reservoir into the needle.
6 When ink is visible in the ink primer sight tube (should take 5-10
seconds), close the ink delivery lines by pushing valve up and
remove the cartridge needle from the ink primer. Note: When you
remove the ink primer from the ink delivery lines, continue pressing
button a few seconds to prevent leaking from the ink primer.
7 Insert the cartridge needle into the hole in the top of the ink cartridge.
Be sure the needle is tightly connected by turning the fitting
clockwise until finger-tight.
8 Gently tighten the fitting (about 1/4 turn) to prevent air leaks. Do not
overtighten. Open the ink delivery lines by pushing the valve down.
9 Wait 20 seconds for the ink pressure to stabilize. Remove the
cartridge from the carriage and remove the blue tape from the jet
area of the cartridge. CAUTION! Do not tilt the cartridge up
higher than a 30 degree angle. This could cause the cartridge
to lose pressure.
NovaJet 500/630/700 Series Printer Quick Start Guide
33