Paper Axis Calibration; Cartridge Recognition - ENCAD 212528-05 Quick Start Manual

Paper axis calibration

Choosing Utility Menu/Calibration Menu/Paper Axis Test lets the printer
draw a set of vertical marks to calibrate the paper axis. To measure the marks
laid down by the printer, you will need a ruler or scale at least 33 inches (838.2
mm) long. (CD#2 of the NovaJet System CD set contains a ruler file than can be
printed on your printer.) The vertical marks should be exactly 33.00 inches
(838.2 mm) apart. If the distance between the marks is different from that
shown on the display, you may adjust the printer by setting its values to match the
length or width you measured. Note: The Paper Axis Test should be
performed every time new media is loaded.
➪ ➪ ➪ ➪ ➪
To print the Paper Axis calibration test pattern
1 Load the printer with media that is at least 36 inches (91 cm) long.
Use the media that you are planning to use for printing.
2 Press Utility Menu/Calibration Menu/Paper Axis Test. The printer
prints two marks.
3 Remove the media from the printer and measure the distance
between the marks. If you need accurate printing (e.g. registering
multiple panels or "tiles"), you must use a very accurate measuring
device. We recommend a steel rule at least 36 inches (91 cm) long
with calibration marks every .01 inches ( 0.254 mm). The distance
between the marks should be exactly 33.00 inches (838.2 mm).
4 If the measurement is not exactly 33.00 inches (838.2 mm), select
Paper Axis and adjust the value to the measurement read on the
steel rule. (e.g. If you read 33.02 on the rule, enter this value in the
printer. It becomes a calibration constant.)
5 Repeat steps 2-4, this time the measurement should be 33.00
inches (838.2 mm).
6 Press Utility Menu/Calibration Menu/Use Calib XY and select
ON.

Cartridge recognition

The printer is designed to use only cartridges specific to your printer model. To
eliminate potential damage to the printer, a Cartridge Recognition feature checks
to ensure that the proper cartridges are installed, and that they are installed
properly. Cartridge recognition is performed when a print request is received
(i.e., image data, prime, etc.).
NovaJet 500/630/700 Series Printer Quick Start Guide
41