ENCAD 212528-05 Quick Start Manual page 24

NovaJet 500/630/700 Series Printer Quick Start Guide
3 Press the button on the ink primer to activate the vacuum and draw
ink through the line.
4 When ink is visible in the ink primer sight tube, remove the cartridge
needle from the ink primer and quickly insert it into the hole in the top
of the ink cartridge. Be sure the needle is tightly connected.
5 Gently tighten the fitting (about 1/4 turn) to prevent air leaks. Do not
overtighten.
6 Remove the cartridge from the carriage and remove the blue tape
from the jet area of the cartridge.
7 Place the suction end of the ink primer over the jet area of the
cartridge. CAUTION! Do not tilt the cartridge up higher than a
30 degree angle. This could cause the cartridge to lose
pressure.
24
Switch
Sight
Tube