Armrest Width Adjustments (Fig. 9); Armrest Angle Adjustment (Fig. 11); Seat Reclining Angle (Fig. 12) - Shoprider Mobility Owner's Manual

Armrest Width Adjustments (Fig. 9)

On the underside of the rear seat there are two hand
knobs/Allen key head bolts, one either side. Loosening the
hand knob or bolt allows the arm rest to be adjusted to the
required width, or removed for transportation.
Armrest Angle Adjustment (Fig. 10)
To adjust the armrests angle on all models except 888SE
Explorer. Flip up the armrests to allow access to the
adjustment screw and lock nut, unscrew the lock nut and
screw the bolt in or out to increase or decrease the angle.
Re-tighten the lock-nut.
Your scooter is dispatched from the factory with the
armrests set parallel to the floor.

Armrest Angle Adjustment (Fig. 11)

To adjust the armrest angle on the 888SE explorer Flip up
the armrest to allow access to the adjustment bolt. Turn the
bolt either up or down to adjust the angle of the armrest.
Ensure you tighten the locking nut at the base of the bolt.
Seat Reclining Adjustment (Fig. 12)
Available on all models except for the 778DXD. The
reclining seat lever is located on the left side below the
armrest. Simply pull the lever up to adjust. This feature also
allows the seat to be folded down for storage and
or transport.
Adjustments
continued
Seat Reclining
11
Figure 9
Adjustment
Screw
Locking Nut
& Screw
Figure 10
Figure 11
Adjustment
Figure 12
Armrest Adjustment
Hand Knob
Adjustment Bolt &
Locking Nut