Care & Maintenance; Wheels And Tyres; Cleaning; General Scooter Maintenance - Shoprider Mobility Owner's Manual

Care & Maintenance

Wheels and Tyres

The wheels of your Shoprider® scooter have split rims. This allows any punctures to be repaired easily.
To change the wheels remove the center 13 mm bolt and slide the wheel off its axle. Take care not to lose the drive key on the
rear wheels. When changing a tyre you must deflate the tyre first. Remove the four bolts to split the rim if required. Ensure
that when refitting the wheel the retaining bolt is fitted with a locking washer (with drive key for the rear wheel). Tyre
pressure is recommended to be kept at 30 psi on the rear tyres and 25 psi on the front. Note when refitting the tube a small
amount of air in the tube will prevent the tube from pinching when reassembling the split rim.
CAUTION: On the tyre it states maximum tyre pressure is 50psi. This is a maximum tyre pressure and the tyres
should never be inflated to this pressure.
ATTENTION: Tyres should be maintained at the correct pressure noted above to ensure even wear and
ride comfort.

Cleaning

Your Shoprider® scooter can be cleaned as required however as with all electrical equipment you must ensure that extreme
care is used to not water damage any sensitive parts.
Please read the following warnings:
Only use a soft damp cloth.
NEVER use a hose to wash your scooter.
DO NOT use abrasive cleaning products – Mild detergent only should be used.

General Scooter Maintenance

Every six months check the tiller base bolts, wheel axle bolts, and arm rest angle adjustment bolts and tighten as necessary.
Also check the seat and arm rest tightening knobs and tighten as needed. If your scooter is fitted with authorised Shoprider®
accessories please check these to ensure the tightening knobs and bolts are secure.

Lubrication

Approximately every six months you should lubricate the following parts on your Shoprider®.
The lubrication points are as follows:
Seat post only.
n
The suggested lubricants should be done with light grade of grease.
Please note: The breather hole on top of the Transaxle is NOT a grease nipple.
PLEASE NOTE ANY OTHER LUBRICATION MUST BE COMPLETED BY AN AUTHORSED SHOPRIDER® DEALER

Servicing

Shoprider® recommends that your scooter be service as a minimum every 12 months for average users and every 6 months
for heavy users. This will ensure that your Shoprider® will continue to deliver the outstanding reliability they are known for.
Please contact the selling Shoprider® dealer to arrange.
22