2.7.10 Soft-Off by PWR-BTTN
If you choose "Instant-Off", then pushing the ATX soft power switch but-
ton once will switch the system to "system off" power mode. You can
choose "Delay 4 sec". If you do, then pushing the button for more than 4
seconds will turn off the system, whereas pushing the button momentarily
(for less than 4 seconds) will switch the system to "suspend" mode.
2.7.11 PowerOn by Modem or Power On by Ring
To enable or disable the function to power on the system via a Modem
connection from a remote host. The choice "Enabled" and "Disabled".
2.7.12 USB KB Wake Up From S3
When enabled, enter any key to wake up the system from S3 state. The
choices are "Enabled" and "Disabled".
2.7.13 PowerOn by Alarm or Resume by Alarm
The choices are "Enabled" and "Disabled". Fields that follow below indi-
cate date of current month and time of alarm settings, if enabled.
2.7.14 Wake-Up by PCI card
When enabled, the system will resume from suspend mode if Primary
IDE 0 (1) or Secondary IDE 0 (1) becomes active. The choices are
"Enabled" and "Disabled".
2.7.15 FDD, COM, LPT PORT
When enabled, the system will resume from suspend mode if the FDD,
interface, COM port, or LPT port is active. The choices are "Enabled"
and "Disabled".
2.7.16 PCI PIRQ [A-D]#
When enabled, the system resumes from suspend mode if an interrupt
occurs. The choices are "Enabled" and "Disabled".
67
Chapter 2 Product Information