Soft-Off By Pwr-Bttn; Cpu Thrm-Throttling; Poweron By Modem; Poweron By Lan - Advantech AIMB-560 Series User Manual

3.7.9 Soft-Off by PWR-BTTN

If you choose "Instant-Off", then pushing the ATX soft power switch but-
ton once will switch the system to "system off" power mode. You can
choose "Delay 4 sec". If you do, then pushing the button for more than 4
seconds will turn off the system, whereas pushing the button momentarily
(for less than 4 seconds) will switch the system to "suspend" mode.

3.7.10 CPU THRM-Throttling

This field allows you to select the CPU THRM-Throttling rate. The
choices: "75.0%", "50.0%", and "25.0%".

3.7.11 PowerOn by Modem

To enabled or disable the function to power on the system via a Modem
connection from a remote host. The choice "Enabled" and "Disabled".

3.7.12 PowerOn by LAN

This item allows you to power on the system by LAN. The choices are
"Enabled" and "Disabled".

3.7.13 PowerOn by Alarm

The choices are "Enabled" and "Disabled".

3.7.14 Primary IDE 0 (1) and Secondary IDE 0 (1)

When Enabled, the system will resume from suspend mode if Primary
IDE 0 (1) or Secondary IDE 0 (1) becomes active. The choices are
"Enabled" and "Disabled".

3.7.15 FDD, COM, LPT PORT

When Enabled, the system will resume from suspend mode if the FDD,
interface, COM port, or LPT port is active. The choices are "Enabled"
and "Disabled".

3.7.16 PCI PIRQ [A-D]#

When Enabled, the system resumes from suspend mode if an interrupt
occurs. The choices are "Enabled" and "Disabled".

3.7.17 PWRON After PWR-Fail

Use this to set up the system after power failure. The "Off" setting keeps
the system powered off after power failure, the "On" setting boots up the
system after failure, and the "Former-Sts" returns the system to the status
before power failure.
AIMB-560 User Manual 52