Table of Contents
Advertisement
3.
IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal
cable. There are three connectors on each Ultra DMA 133/100/66 signal
cable: blue, black, and gray. Connect the blue connector to the mother-
board's IDE connector, then select one of the following modes to config-
ure your device.
Drive jumper setting
Single
Cable-Select or Master
device
Two
Cable-Select
devices
Master
Slave
Note:
Pin 20 on the IDE connector is removed to match the covered
hole on the Ultra DMA cable connector. This prevents incor-
rect insertion when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66
IDE devices.
Note:
If any device jumper is set as "Cable-Select," make sure all
other device jumpers have the same setting.
P5B-VM DO IDE connector
Figure 1.11: AIMB-564 IDE connector
Mode of device(s) Cable connec-
-
Master
Slave
Master
Slave
PRI_EIDE
PIN1
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
35
Chapter 1 Product Information
tor
Black
Black
Gray
Black or gray
Advertisement
Table of Contents
