Table of Contents
Advertisement
3.7.9 Soft-Off by PWR-BTTN
If you choose "Instant-Off", then pushing the ATX soft power switch but-
ton once will switch the system to "system off" power mode. You can
choose "Delay 4 sec". If you do, then pushing the button for more than 4
seconds will turn off the system, whereas pushing the button momentarily
(for less than 4 seconds) will switch the system to "suspend" mode.
3.7.10 PowerOn by LAN
This item allows you to power on the system by LAN. The choices are
"Enabled" and "Disabled".
3.7.11 CPU THRM-Throttling
This option controlls the CPU speed as a percentage of regular power. the
choices are 87.5%, 75%, 62.5%, 50%, 37.5%, 25% .12% and 12.5%.
3.7.12 PowerOn by Modem
To enabled or disable the function to power on the system via a Modem
connection from a remote host. The choice "Enabled" and "Disabled".
3.7.13 PowerOn by Alarm
The choices are "Enabled" and "Disabled". Fields that follow below
indicate date of current month and time of alarm settings, if enabled.
3.7.14 Primary IDE 0 (1) and Secondary IDE 0 (1)
When Enabled, the system will resume from suspend mode if Primary
IDE 0 (1) or Secondary IDE 0 (1) becomes active. The choices are
"Enabled" and "Disabled".
3.7.15 FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if the FDD,
interface, COM port, or LPT port is active. The choices are "Enabled"
and "Disabled".
3.7.16 PCI PIRQ [A-D]#
When Enabled, the system resumes from suspend mode if an interrupt
occurs. The choices are "Enabled" and "Disabled".
3.7.17 PWRON After PWR-Fail
Use this to set up the system after power failure. The "Off" setting keeps
the system powered off after power failure, the "On" setting boots up the
system after failure, and the "Former-Sts" returns the system to the status
before power failure.
57
Chapter 3
Advertisement
Table of Contents
