Table of Contents
Advertisement
10. Press the power button on the left hand corner of your NAS server.
11. Wait for the server to boot up. The boot up process takes approximately 2 minutes.
2.2 Sliding Rails Installation
1. Make sure that you have the following the mounting parts for the sliding rails.
•
4 L-shaped brackets (see the left side of the photo)
•
8 x "M4" size screws, 8 x "M5" size screws and 6 x "#6-32" size screws.
2. Take the sliding rail apart by sliding out the center slide. Push down the hook to separate them. Pull
the center slide all the way until it reaches the end.
3. Now install the center slide to the rack-mount chassis. Find the screw holes on both sides of the
rack-mount chassis, which are used for mounting the center slide. Fasten the "#6-32" screws to fix
the center slides onto chassis. Later, the center slides will be used for attaching to the sliding rail.
#6-32
13
Advertisement
Table of Contents
