Hardware Installation; Desktop Installation; Rack Mounting - Planet FGSW-2402VS User Manual

2. In some area, installing a surge suppression device may also help to protect your Web Smart Switch from being
damaged by unregulated surge or current to the Web Smart Switch.

2.3 Hardware Installation

T his part describes how to install your Web Smart Ethernet Switch and make connections to the Switch. Please read the
following topics and perform the proce
or shelf, simply completed the followi

2.3.1 Desktop Installation

T o install Web Smart Switch on a desktop or shelf, simply completed the following steps:
Step 1: Attached the rubber feet to
Step 2: Place the Web Smart Switch on a desktop or shelf near an AC power source.
Step 3: Keep enough ventilation space between the Web Smart Switch and the surrounding obje
When choosing a location, please keep in mind the environmental restrictions di
Chapter 1, Section 4, Specification.
Notice:
Step 4 : Connect your Switch to network devices.
Connect one end of a standard network cable to the 10/100 RJ-45 ports on the front of the Web Smart Switch.
A .
Connect the other end of the cable to the netw
B.
Connection to the Web Smart Switch requires UTP Category 5 network cabling with RJ-45 tips. F
more information, please see the Cabling Specification in Appendix A.
Notice:
Step 5 : Supply power to the Web Smart Switch.
Connect one end of the power cable to the Web Smart Switch.
A .
Connect the power plug of the power cable to a st
B.
When the Web Smart Switch receives power, the Power LED should r

2.3.2 Rack Mounting

T o install the Web Smart Switch in a 19-inch standard rack, follow the instructions described below.
Step 1: Place your Web Sma
Step 2: Attach a rack-mount bracket to each side of the Web Smart Switch with supplied screws attache
Figure 2-6 shows how to attach brackets to one side of the Web Smart Switch.
Caution:
You must use the screws su
w
ould invalidate your warranty.
dures in the order being presented
ng steps.
the recessed areas on the bottom of the Web Smart Switch.
ork devices such as printer servers, workstations or routers...etc.
rt Switch on a hard flat surface, with the front panel positioned towards your front side.
Figure 2-6 Attaching the brackets to the Web Smart Switch
pplied with the mounting brackets. Damage caused to the pa
. T o install your Web Smart Switch on a desktop
andard wall outlet then power on the Web Smart Switch.
emain solid Green.
cts.
scussed in
d to the package.
rts by using incorrect screws
or
- 10 -