Mil-Std-1553 Triggering; Press The Trigger Softkey; Then, Turn The Entry Knob To Select The Trigger Condition - Agilent Technologies 4000 X-Series User Manual

MIL-STD-1553 Triggering

To set up the oscilloscope to capture a MIL- STD- 1553 signal, see
for MIL- STD- 1553 Signals"
To set up a MIL- STD- 1553 trigger:
1 Press [Trigger].
2 In the Trigger Menu, press the Trigger softkey; then, turn the Entry knob
3 Press the Trigger softkey; then, turn the Entry knob to select the trigger
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
to select the serial slot (Serial 1 or Serial 2) on which the
MIL- STD- 1553 signal is being decoded.
condition:
Data Word Start — triggers on the start of a Data word (at the end of a
•
valid Data Sync pulse).
Data Word Stop — triggers on the end of a Data word.
•
Command/Status Word Start — triggers on the start of Command/Status
•
word (at the end of a valid C/S Sync pulse).
Command/Status Word Stop — triggers on the end of a Command/Status
•
word.
Remote Terminal Address — triggers if the RTA of the Command/Status
•
word matches the specified value.
When this option is selected, the RTA softkey becomes available and
lets you select the hex Remote Terminal Address value to trigger on.
If you select 0xXX (don't cares), the oscilloscope will trigger on any
RTA.
Remote Terminal Address + 11 Bits — triggers if the RTA and the
•
remaining 11 bits match the specified criteria.
When this option is selected, these softkeys become available:
The RTA softkey lets you select the hex Remote Terminal Address
•
value.
The Bit Time softkey lets you select the bit time position.
•
MIL-STD-1553/ARINC 429 Triggering and Serial Decode
on page 445.
27
"Setup
447