Passive Probes; Single-Ended Active Probes - Agilent Technologies 4000 X-Series User Manual

Passive Probes

InfiniiVision 4000 X- Series oscilloscopes recognize passive probes such as
the N2894A, 10070D, N2870A, etc. These probes have a pin on their
connector that connects to the ring around the oscilloscope's BNC
connector. Therefore, the oscilloscope will automatically set the
attenuation factor for recognized Agilent passive probes.
Passive probes that do not have a pin that connects to the ring around
the BNC connector will not be recognized by the oscilloscope, and you
must set the probe attenuation factor manually. See
attenuation"
The following passive probes can be used with the InfiniiVision
4000 X- Series oscilloscopes. Any combination of passive probes can be
used.
Table 5
Model
10070D
10076B
N2771B
N2870A
N2874A
N2876A
N2894A

Single-Ended Active Probes

The following single- ended active probes can be used with the
InfiniiVision 4000 X- Series oscilloscopes.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
on page 86.
Passive Probes
Description
Passive probe, 1:1 20 MHz, 1.5 m
High-voltage passive probe, 100:1, 4 kV, 250 MHz
High-voltage passive probe, 1000:1, 30 kV, 50 MHz
Passive probe, 1:1 35 MHz, 1.3 m
Low impedance passive probe, 10:1, 1.5 GHz, 500 ohm input Z, 1.3 m
Low impedance passive probe, 100:1, 1.5 GHz, 5 kohm input Z, 1.3 m
Passive probe, 10:1, 700 MHz, 1.3 m
Reference
"To specify the probe
371
22