Basic Commands - Interlogix Concord 4 User Manual

Basic commands

Table 1 below shows the basic commands.
Table 1: Basic commands
Command
Disarm the system
Cancel an accidental alarm
Arm to Level 2 (stay)
Arm to Level 3 (away)
Send a police alarm
Send an auxiliary alarm
Send a fire alarm
Arm system with no delay
Arm system for latchkey
Bypass a sensor
Arm system silently
Arm system with exit light off
Turn all lights on/off
Turn specific lights on/off
Check the system status
Turn chime on/off
Turn energy saver on/off
Disable local phone access
(phone command only)
Check alarm memory
Activate output
View event history
Concord 4 User Manual
Instructions
Press 1, code.
Press code or press 1, code.
Press 2, code.
If the quick arm feature is on, an access code is not required.
Press 3, code.
If the quick arm feature is on, an access code is not required.
Press and hold both Police buttons for 2 seconds.
Press and hold both Auxiliary buttons for 2 seconds.
Press and hold both Fire buttons for 2 seconds.
Press 2, code, 4 (Level 2), or press 3, code, 4 (Level 3).
If the quick arm feature is on, an access code is not required.
Press 2, code, 6 (Level 2), or press 3, code, 6 (Level 3).
If the quick arm feature is on, an access code is not required.
Indirectly: Press 2, code, # (Level 2), or press 3, code, # (Level
3).
Directly: Press #, code, sensor number.
If the quick arm feature is on, an access code is not required.
Press 5, 2, code (Level 2), or 5, 3, code (Level 3).
If the quick arm feature is on, an access code is not required.
Press 2, code, 0 (Level 2), or 3, code, 0 (Level 3).
If the quick arm feature is on, an access code is not required.
Press 0, 0.
Press 0, light number.
Short status: Press *.
Full status: Press *, *.
Press 7, 1.
Press 7, 2.
Press #, 7, 3 or wait 5 seconds after picking up the phone.
Your installer can disable local phone control if desired.
Press 7, 6.
Press 7, 7, output number (1 to 6).
This must be set up by the installer.
Press 8, code, 8.
5