Scheduled Outputs - Interlogix Concord 4 User Manual

The touchpad displays LIGHT n TO SN x or LT n SN x (where n is the
light number and x is the sensor number).
3. Press A or B until the light number (1 to 9) you would like to deactivate
appears.
4. Enter the sensor number as 0 (no sensor) and press #.
5. Press *, 00, # to exit the programming menus.
Installer programmable lighting
If you would like specific lights to turn on during entry and exit delay times, or if
you would like a light to flash to indicate successful arming and disarming,
contact your installer.

Scheduled outputs

You can use outputs to control devices in your home (such as automatic window
blinds). Outputs that your installer has enabled, can be turned on or off according
to time schedules. If you need assistance setting up a time schedule that fits your
needs, see "Time schedules" on page 31.
To schedule outputs:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. Press 065, #.
The touchpad displays OUTPUTS.
3. Press #.
4. Press B until the touchpad displays the output number you would like to
schedule.
See "Outputs" on page 82 to determine which output is associated with which
output number.
5. Press #.
The touchpad displays the first available time schedule.
6. Press 2, # to assign the time schedule (on) for this output, or press 1, # to
make the time schedule inactive (off) for this output.
7. Press B to go to the next time schedule, or press *, 00, # to exit the
programming menus.
36 Concord 4 User Manual