Interlogix Concord 4 User Manual page 15

Quick arm
You must contact your installer if you want to use this feature. This feature lets
you arm your system without using an access code. (Disarming the system still
requires entering an access code.)
• To quick arm to Level 2, from Level 1, press 2.
• To quick arm to Level 3, from Level 1 or 2, press 3.
Quick exit
Your system may be set up to let you exit and reenter the premises within 2
minutes, without disarming and rearming the system. This is useful when, for
example, you want to quickly step outside to pick up the newspaper without
disarming your system.
1. When the system is armed to Level 2, press D at any touchpad (opening the
door without pressing D will cause an alarm).
2. Open a designated delay door and go outside. Remember to leave the door
open if you are planning to come back in.
3. Return within 2 minutes and close the door. The system will rearm to Level 2.
Keychain touchpad arming
Your installer can set up your keychain touchpad to arm the system in one of two
ways:
• Press the Lock button to arm the system directly to Level 3 with no exit or
entry delay. Using this method, you would not be able to arm to Level 2.
• Press the Lock button once for each desired increase in arming level. For
example, for Level 1 press the Lock button once to arm to Level 2, press it
twice for Level 3, or press it three times to arm to Level 3 with latchkey
activated (if programmed). The exit delay time is applied. For more
information see "Latchkey paging" on page 38.
• Press the Star button (if enabled) to remove the entry/exit delay if armed to
Level 2 or 3.
Your system can be set up to sound short beeps on exterior sirens when
Note:
arming or disarming the system from outside using a keychain or wireless
touchpad. This provides confirmation that an arming level change was
successful. Ask your installer about this feature.
Concord 4 User Manual 13