Notify By Exception - Interlogix Concord 4 User Manual

Or, to schedule latchkey closing, press B until the touchpad displays
LATCHKEY CLOSING or LATCH CLOSE, and then press #.
Note: If you want a page to be sent every time latchkey-designated user
codes arm or disarms the system, apply the same time schedules under
latchkey opening and latchkey closing.
The touchpad displays the first available time schedule.
4. Press 2, # to assign the time schedule to the event, or press 1, # to make the
time schedule inactive for the event.
5. Press B to go to the next schedule, or press *, 00, # to exit the programming
menus.
Latchkey modifier
The latchkey modifier (6) is pressed after the arming keypress sequence.
To apply the latchkey modifier from a touchpad, press 2 or 3, code, 6. The
touchpad displays LATCHKEY PAGER ON or PAGER ON.
You must press 6 within 5 seconds of arming. If the quick arm feature is
Note:
on, an access code is not required. See "Quick arm" on page 13 for more
information.
To apply the latchkey modifier using a keychain touchpad, press the Lock button
when the system is armed to Level 3.

Notify by exception

The notify by exception feature allows programmed pager holders and/or the
central station to be notified when arming or disarming occurs outside the
specified time schedules.
Every morning you would like to be notified if your business is
Example:
disarmed after its normal opening time, and/or every evening you would like to be
notified if your business is armed before its normal closing time.
You can set this feature to page in the following instances:
• Send a page if the system is disarmed before the opening time schedule
begins or after the opening time schedule has ended (exception opening).
• Send a page if the system is armed before the closing time schedule begins
or after the closing time schedule has ended (exception closing).
Your system can call up to five different pager numbers to report an open
exception or closed exception. You can request that the central station receive
these two reports as well. See "Paging" on page 80 to see which pagers have
been set up to receive a page for this feature. Contact the installer if you would
like to turn this feature on or off for any programmed pager or the central station.
40 Concord 4 User Manual