Connecting The Modem To Your Pc; Connecting The Usb; Connecting The Line; Connecting A Phone - Multitech MT9234ZBA-USB-CDC-XR User Manual

Chapter 2 – Installing the Modem

Connecting the Modem to Your PC

Placing the modem in a convenient location, connect it to your computer's USB port, to the telephone line, and,
optionally, to your telephone.

Connecting the USB

Plug one end of the USB cable into the USB connector on the modem, and the other end into a USB port
connector on your computer.

Connecting the Line

Plug one end of the phone cable into the modem's LINE jack and the other end into a phone line wall jack.
Note: The LINE jack is not interchangeable with the PHONE jack. Do not plug the phone into the LINE jack or the
line cable into the PHONE jack.
Note: The Federal Communications Commission (FCC), and Industry Canada impose certain restrictions on
equipment connected to public telephone systems. See Appendix A for more information. .

Connecting a Phone

For voice-only calls, you can optionally plug a telephone into the modem's PHONE jack.

Installing the Modem Driver

After you install the driver, test the operation of your new MT9234ZBA-USB by registering it. Open an Internet browser, then
go to the URL that follows. Instructions at the website explain how to register the modem.
http://www.multitech.com/en_US/TOOLS/Forms/register/warranty.asp

Manually Installing the MT9234ZBA-USB-CDC in Windows 7

Connect the MT9234ZBA-USB-CDC to an available USB port.
1.
Windows 7 reports that the driver software was not successfully installed. You must manually point Windows 7 to the
drivers needed.
From Windows Start button, select Control Panel.
2.
Click Hardware and Sound.
3.
MT9234ZBA-USB-CDC-XR User Guide
8