Using The 5310 Ip Conference Unit; Accessing/Exiting The Conference Controller Application; Turning The Conference Unit On And Off - Mitel 5320e User Manual

Using the 5310 IP Conference Unit

Your IP phone can use the 5310 IP Conference Unit (shown below) for full-duplex, advanced
IP conferencing. Use the Conference Controller touch screen to turn the Conference Unit on
or off, to adjust the volume or to put the Conference Unit into Presentation mode. You can only
run one Conference Controller session at a time. If the 5310 Conference Unit is not connected
to your IP phone, the Conference Controller application is not available.
Installation instructions are included with the unit.
For information about placing conference calls and adding parties to the conference, see
"Placing Conference Calls" on

Accessing/Exiting the Conference Controller Application

You must first access the Conference Controller application to use the Conference Unit.
To access the Conference Controller application:
1. Press (Applications).
2. Press Conference Unit.
To exit the Conference Controller application:
• Press Close in the Conference Controller application.

Turning the Conference Unit On and Off

The following instructions describe how to turn the Conference Unit on and off.
To turn the Conference Unit on and off:
Press Turn On or Turn Off in the Conference Controller application. If applicable, the
appears in the IP phone status line while the Conference Unit is on.
Note: Turning the 5310 Conference Unit off terminates the active call. To continue the
call either pick up the handset or press the Speaker button on the IP phone.
Mitel 5310 IP Conference Unit
5310 IP Conference Unit
page 47.
Getting Started
icon
13