Problem Solving Chart; Clearing A Film Jam Or Break - Kodak i7300 User Manual

Problem solving
chart
Problem
The 3 front LEDs on the
scanner are on and will not go
off.
Clearing a film jam
or break
A-61404 February 2003
Use the chart below as a guide to check possible solutions to problems you may
encounter when using the scanner.
Reset the circuit breaker on the back of the scanner. If the problem persists,
call service.
If a film jam or film break occurs in the take-up area, the jammed or
broken film must be removed in order to continue operations.
Tools needed:
The following will help in the film recovery procedure:
A piece of heavier film or film leader approximately 2 ft. (61 cm) in
length to manually slide through the film path to help move the
broken or loose film.
Scissors to cut the damaged end of the film, if required.
To clear a film jam or break:
1. Turn off the scanner.
2. Open the side panel of the scanner by lifting the two side indents to
release the catches and gently pulling the side cover down.
3. Use the Manual Release Lever to release the supply spindle from the
film magazine.
4. Remove the magazine from the film slot. Take note of the
orientation of the magazine before removing it.
5. Set the magazine aside.
Possible Solutions
15