Dual Stacking Toggle Patch; Adjusting The End Stop; Overriding Controlled Dual Stacking; Problem Solving - Kodak i5000 Series User Manual

Adjusting the end stop

Overriding
Controlled Dual
Stacking
Dual Stacking Toggle
Patch

Problem solving

Problem
Documents are not separating
Documents with patch codes are not
stacking in Stack #2 correctly
Some documents are not stacking
neatly in Stack #1
Documents stop in the scanner
A-61670 August 2014
You can also adjust the end stop. It is recommended that the end stop be
adjusted about 1.5 inches (38.1 mm) longer than the longest document that
will be deposited into Stack #2. Use the thumbscrews on the bottom of Stack
#1 to make adjustments.
1. Loosen both screws on the bottom of Stack #1.
2. Slide the end stop in or out to the desired length.
3. Tighten both screws.
Controlled Dual Stacking can be overridden by using the Overrides screen on
the Operator Control Panel. See the section entitled, "Scan job overrides -
Dual Stacking" in Chapter 3 for more information.
Dual Stacking Toggle Patch can be enabled from the Operator Control Panel.
See the section entitled, "Settings screen: Dual Stacking Toggle Patch" in
Chapter 3 for more information.
Use the list below as a guide to check possible solutions to problems you may
encounter when using the Controlled Dual Stacking Accessory.
Possible Solution
• Verify that the Controlled Dual Stacking Accessory has been enabled
by a Service Representative.
• Try copying the patch sheet on a stiffer paper. Using stiff paper stock
for printedpatch sheets will allow the pages to be output into Stack #2
more reliably.
• For neater stacking you can use a jogger to align document edges
before scanning.
• The Length Protection option is limiting the scanner to only allow
landscape feeding. See the section entitled, "Length Protection
Enabled" earlier in this chapter for more information.
5-7