Maintenance; Replacing The Projection Lamp - Kodak i7300 User Manual

3

Maintenance

Replacing the
projection lamp
8
When the projection lamp burns out, replace the projection lamp as
follows:
WARNING: If the scanner has been in use, the lamp
1. Turn off the scanner.
2. When you are sure the projection lamp area is cool, open the side
panel.
3. Pull the lever back to release the bulb and pull the lamp straight out
from the lamp housing.
4. Hold the lamp socket in one hand and use the other hand to pull the
lamp away from the socket.
assembly will be HOT. Allow the lamp
area to cool a minimum of 5 minutes
before attempting to change the lamp.
A-61404 February 2003