Table of Contents
Advertisement
Rev 1.0
RX bytes:
RX packets:
RX mcast packets: 0
RX discards:
RX errors:
RX overruns:
RX frame:
6. Run the command:
show version
7. Compare the results of this command with the latest version for your switch posted on the
support page for your
Starting the Command Line (CLI)
1. Set up an Ethernet connection between the switch and a local network machine using a stan-
dard RJ-45 connector.
2. Start a remote secured shell (SSH) to the switch using the command "ssh -l <username>
<switch ip address>."
3. Login to the switch (default username is admin, password admin)
4. Once you get the prompt, you are ready to use the system. Refer to MLNX-OS Command Ref-
erence Guide for additional information on the CLI commands.
Rerunning the Wizard
5. If you want to rerun the wizard run the following commands:
switch > enable
switch# configure terminal
switch (config) # configuration jump-start
3.6.2
Starting a Remote Connection to the Switch
There are two ways to access the management CPU:
• Via the Ethernet connector for remote access:
42
Mellanox Technologies
1343502058
17589211
0
0
0
0
Confirm that the latest SW revision is installed on this device. Use the CLI to get the
currently installed revision and then go to Mellanox.com to check the revision of the
latest version.
switch. This page will need a support login and password.
rem_mach1 > ssh -l <username> <ip address>
Mellanox MLNX-OS Switch Management
Last login: Thu Apr 28 11:24:13 2011 from 192.168.10.1
Mellanox Switch
switch >
TX bytes:
313920869
TX packets:
992717
TX discards:
0
TX errors:
0
TX overruns:
0
TX carrier:
0
TX collisions: 0
TX queue len:
1000
Installation
Advertisement
Table of Contents
