Cutter Module Installation - Godex EZ-1100Plus User Manual

3-2. Cutter Module Installation

1 Cutter Module
2 Screw (TAP 3*8) x 2pcs
【 】
Note1
Please power off the printer
before installing the cutter
module.
【 】
Note2
Do not cut self-adhesive
labels! The traces of adhesive
will pollute the rotary knife and
impair safe operation! The
service life of the cutter is
500,000 cuts with 160g/
paper weight and 250,000
㎡
cuts with 200g/ paper
weight.
1. Open the top cover by
pressing the Cover
Open Buttons on both
sides.
2. Loosen and then lift the
upper print mechanism
by pressing the locking
tenons.
3. Unlock the front cover
piece by pushing locks
inward.
4. Lift/take off the front
cover piece according to
the direction shown in
the figure.
5. Plug in the cable
connector of the cutter
module onto the
switchboard socket.
【 】
Note
Before plug the connector into
socket, please check the pin
first.
EZ-1000Plus User's Manual
【 】
Note3
㎡
The max paper cutting width is 116mm
【 】
Note4
The label / paper that used for cutting is suggested to be at
least 30mm in height.
21
1
2