HYOSUNG Sense SD-50 Service Manual page 95

INSPECTION
WHEEL RIM
Make sure that the wheel rim runout does not exceed the service
limit when checked as shown.
An excessive runout is usually due to worn or loose wheel bearings
and can be reduced by replacing the bearings. If bearing replace-
ment fails to reduce the runout, replace the wheel.
Service limit
(Axle and Radial)
TIRE
Inspect the tires for wear and damage;and check the tire tread
depth as shown. Replace a badly worn or damaged tire. A tire with
its tread worn down to the limit(in terms of tread depth)must be
replaced.
TIRE DEPTH SERVICE LIMIT
Front & Rear
Check the tire pressure, and examine the value for evidence of air
leakage.
TIRE DEPTH SERVICE LIMIT
COLD INFLATION
TIRE PRESSURE
FRONT
REAR
REASSEMBLY AND REMOUNTING
Reassemble and remount the front wheel in the reverse order
diassembly and removal, and also carry out the following steps.
WHEEL BEARING
● Apply grease to the bearings before installing.
99000-07C00
● Install the wheel bearings by using the special tool.
09924-84520
CAUTION:
First install the wheel bearing for left side.
3 .0 mm(0.12 in)
1.6 mm(0.064 in)
NORMAL RIDING
SOLD RIDING
kPa kg/㎠ kPa
125 1.25 －
200 2.00 －
Grease "G
Bearing installer
DUAL RIDING
kg/㎠
－
－
"
2
Special tool
3
CHASSIS 6-10