HYOSUNG Sense SD-50 Service Manual page 84

RECHARGING OPERATION
● Using the pocket tester, check the battery voltage. If the voltage
reading is less than 12.0V(DC), recharge the battery with a bat-
tery charger.
CAUTION:
When recharging the battery, remove the battery from the
motorcycle.
NOTE:
Do not remove the sealing cap off the battery top while
recharging.
Recharging time
CAUTION:
Be careful not to allow the charging current to exceed 4A
at any time.
● After recharging, wait for more than 30 minutes and check the
battery voltage with a pocket tester.
● If the battery voltage is less than 12.5V, recharge the battery
again.
● If the battery voltage is still less than 12.5V after recharging,
replace the battery with a new one.
● When a battery is left for a long term without using, it is subject
to discharge. When the motorcycle is not used for more than 1
month(especially during the winter season), recharge the battery
once a month at least.
0.4A for hours or
4.0A for half an hour
ELECTRICAL SYSTEM 5-12