HYOSUNG Sense SD-50 Service Manual page 29

3-7 ENGINE
● Loosen the clutch shoe nut with the special tool.
09930-40113
● Remove the nut while holding down the clutch shoe assembly by
both hands as shown in the illustration.
WARNING:
Gradually back off the clutch shoe assembly pressed
down by hand to counter the clutch spring load.
Releasing the hand suddenly may cause the parts to
fly apart.
① Nut
② Clutch shoe assembly
③ Spring
C A U T I O N :
D o n o t a t t e m p t t o d i a s s e m b l e t h e c l u t c h s h o e
a s s e m b l y .
I t i s n o t s e r v i c e a b l e .
● Using a thin blade screwdriver or the like, pry up the movable
driven face spring guide ④.
● Remove the pins ⑤, movable driven face ⑥ and fixed driven
face ⑦.
● Remove the roller bearing � with the special tools.
09923-73210
09930-30102
CAUTION:
The removed bearing should be replaced with a new one.
Rotor holder
②
①
③
Bearing remover
Sliding shaft
①
②
④
⑤
⑦
⑥
Special tool
Special tool
�