HYOSUNG Sense SD-50 Service Manual page 48

● When installing the cam lever ④ to the cam, align the punched
mark with the slit of cam lever.
● Tighten the cam lever nut ⑤ to the specified torque.
Tightening torque
● Install the brake shoes.
● Apply grease to the camshaft and pin before installing the brake
shoes.
99000-07000
CAUTION:
Be careful not to apply too much grease to the
camshaft and pin. If grease gets on the lining, brake
effectiveness will be lost.
● Install the rear wheel and nut.
Tightening torque
6-9 N∙m
(0.6-0.9 kg-m, 4.5-6.5 lb-ft)
Grease "G "
2
60-90 N∙m
(6.0-9.0 kg-m, 43.5-65.0 lb-ft)
Punched
mark
Slit
④
ENGINE 3-26
⑤
④