HYOSUNG Sense SD-50 Service Manual page 94

6-9 CHASSIS
● Remove the disc plate ① by removing the bolts.
● Remove the spacer.
● Remove the dust seal ③ with the special tool.
09913-50121
● Drive out the both bearing with the special tool in the following
procedures.
● Insert the adapter into the bearing.
● After inserting the wedge bar from the opposit side, lock the
wedge bar in the slit of the adapter.
● Drive out the bearing by knocking the wedge bar.
09941-50110
CAUTION:
T h e r e m o v e d d u s t s e a l a n d b e a r i n g s h o u l d b e
replaced with new ones.
Oil seal remover
Bearing remover
①
②
③