HYOSUNG Sense SD-50 Service Manual page 56

● Install the movable drive face cover ⑦.
NOTE:
Make sure that the movable drive plate is fully positioned
inside, or the weight roller may come off.
● Insert the spacer.
● Position the movable drive face subassembly on the crankshaft
as shown in the photo.
NOTE:
Thoroughly clean the belt contact to be from oil.
● Install the fixed drive face ⑧.
● Tighten the nut ⑨ to the specified torque with the special tool.
09910-20115
Tightening torque
● Fill grease in the groove provided inside sliding surface of the
kick driven gear and install it ⑩ on the end of the crankshaft.
Wipe off excess grease.
99000-07000
● Install the spring ⑪ and spacer ⑫.
● Install the E-ring ⑬.
Conrod holder
40-60 N∙m
(4.0-6.0 kg-m, 29.0-43.5 lb-ft)
Grease "G "
2
ENGINE 3-34
⑦
Spacer
⑧
⑨
⑪
⑩
⑬
⑫
Apply grease
⑩
⑪
⑫
⑬