HYOSUNG Sense SD-50 Service Manual page 82

BATTERY
SPECIFICATION
Type designation
Capacity
Standard electrolyte S.G.
INITIAL CHARGING
FILLING ELECTROLYTE
● Remove the aluminum tape ① sealing the battery electrolyte
filler holes.
● Remove the caps ②.
NOTE:
A f t e r f i l l i n g t h e e l e c t r o l y t e c o m p l e t e l y , u s e t h e
removed cap ② as the sealed caps of battery-filler
holes.
Do not remove or pierce the sealed areas ③ of the
electrolyte container.
● Insert the nozzels of the electrolyte container into the battery、 s
electrolyte filler holes, holding the container firmly so that it does
not fall. Take precaution not to allow any of the fluid to spill.
● Make sure air bubbles are coming up each electrolyte container,
and leave in this position for about more than 20 minutes.
YTX4L-BS
12V, 3AH/10HR
1.32 at 20 ℃(68℉)
ELECTRICAL SYSTEM 5-10