Turn On And Off The Océ Tds100 - Oce TDS100 User Manual

Turn on and off the Océ TDS100
Introduction
When you turn on the Océ TDS100, you can use the Océ TDS100 immediately.
After you finished your copy job, you can leave the Océ TDS100 on, because
the Océ TDS100 turns into the sleep mode within two minutes. The power use
is very low in the sleep mode. You can recognise the sleep mode when only the
green light on the operator panel illuminates and the other indicators are off.
The Océ TDS100 activates from the sleep mode when you do one of the
following.
Feed an original
Feed the media manually
Push a key on the operator panel
Open a roll unit.
Illustration
[5] The On / off switch at the back of the Océ TDS100
[5] The On / off switch at the back of the Océ TDS100
How to turn on the Océ TDS100
Set the On / off switch at the back of the Océ TDS100 to position 1.
1.
Result
The green light at the operator panel illuminates and indicates that the Océ
TDS100 is in sleep mode.
22 User manual